Appendix A - Specifi Cations And Optional Equipment - Sensata Magnum-Dimensions MagnaSine MS-G Series Owner's Manual

Appendix A – Specifi cations and Optional Equipment
A-1 Inverter/Charger Specifi cations
Inverter Specifi cations
Input battery voltage range
Absolute maximum DC input
AC output voltage accuracy
Output frequency and accuracy
Total Harmonic Distortion (THD)
Continuous power output (at 25°C)
Continuous AC output current
1 msec surge current (amps AC)
100 msec surge current (amps AC)
5 sec surge power (real watts)
30 sec surge power (real watts)
5 min surge power (real watts)
30 min surge power (real watts)
Maximum continuous input current
Inverter effi ciency (peak)
HBCO/HBCI (High Battery Cut Out/In)
LBCO/LBCI (Low Battery Cut Out/In)
Series Stacking for 120/240 VAC
AC Relay Transfer time (minimum)
Power Consumption – searching
Power Consumption – inverting (no load)
Output Waveform
Charger Specifi cations
Continuous charger output at 25°C
Input current for continuous rated output
Charger effi ciency
AC input frequency range
AC input voltage range
Power factor
General Features and Capabilities
Transfer relay capability
Five-stage charging capability
Battery temperature compensation
Internal Cooling
Overcurrent protection
Over-temperature Protection
Corrosion protection
Safety Listings
Warranty
Environmental Specifi cations
Operating temperature
Non-Operating temperature
Operating humidity
Physical Specifi cations
Unit Dimensions (length x width x height)
Shipping Dimensions (l x w x h)
Mounting
Unit Weight
Shipping Weight
Max operating altitude
** MS2000-G models
© 2015 Sensata Technologies
Models MS2000-G/MS2012-G
2000 VA
16.7 AAC
3300
3100
2800
2200
266 ADC
90.6%
25 watts
100 ADC
15 AAC
30 AAC max each wired input (30AAC total on MS2000-G's, 50AAC total on other models)
Bulk, Absorb, Float, Equalize (requires remote), and Battery Saver™
Standard with available temp sensor connected (battery temp 0 – 50 °C)
0 to 120 cfm variable speed drive using dual 92 mm brushless DC fan
PCB's conformal coated, powder coated chassis/top, and stainless steel fasteners
ETL listed to UL/cUL 458, UL 1741, CSA C22.2 No. 107.1-01, and meets KKK-A-1822E std**
3 years parts and labor (extends to 5 yrs with MMP system)
13.75" x 12.65" x 8.0" (34.9 cm x 32.1 cm x 20.3 cm) [MS2000-G height is 7.0"/17.8 cm]
Shelf or wall (vents not to face downward unless ME-CB/MPX-CB or MMP is installed)
42 lb (19.1 kg) / 55 lb (24.9 kg)
50 lb (22.7 kg) / 63 lb (28.6 kg)
ETL listed to UL/cUL 458, CSA C22.2 No. 107.1-01, and meet KKK-A-1822E standard.
Specifi cations @ 25°C - Subject to change without notice.
Appendix A – Specifi cations
MS2812-G
9.0 to 16.9 VDC
25 VDC
120 VAC ±5% (≤ continuous power)
60 Hz ± 0.1 Hz
< 5%
2800 VA
23 A
50 70
33 40
3900
3800
3200
3000
373 ADC
90%
16.9 VDC/16.6 VDC
9.0 VDC (adj)/12.5 VDC
No
16 msec
<8 watts
30 watts
Pure Sine Wave
125 ADC
18 AAC
85%
50 to 70 Hz
60 to 140 VAC (120 VAC nominal)
> 0.95
30A max wired output or 20A GFCI output
with two overlapping circuits
on transformer, MOSFETS, and battery
-20°C to +60°C (-4°F to 140°F)
-40°C to +70°C (-40°F to 158°F)
0 to 95% RH non-condensing
19" x 17" x 13" (48.3 cm x 43.2 cm x 33 cm)
55 lb (24.9 kg)
63 lb (28.6 kg)
15,000' (4570 m)
MS4024-G
18.0 to 33.8 VDC
35 VDC
4000 VA
33 A
120
82
5800
5400
4900
4500
267 ADC
93.7%
33.8 VDC/33.2 VDC
18.0 VDC (adj)/25.0 VDC
Yes, using two MS4024-G's
25 watts
105 ADC
29 AAC
55 lb (24.9 kg)
63 lb (28.6 kg)
Page 54