Table of Contents
Advertisement
Page
Ver.
Item
PRE KNEE/
WHITE CLIP
ZEBRA
WHITE CLIP
ZEBRA1 LEVEL, XXX ([XX])
RANGE
ZEBRA2 LEVEL XXX ([XX])
Z.DISP
TEST
VTR/CCU
VTR R-Y
VTR B-Y
CCU Y SAMP
CCU R-Y SYNC XXX ([XX])
CCU B-Y SAMP XXX ([XX])
RGB OFFSET
TEST
CB
IRIS
LEVEL
APL RATIO
BVP-500
BVP-500P
Settings
Contents
XXX ([XX])
Adjusts the white clip level.
[ON], OFF
Turns the white clip function on and off.
Sets the center value and range for the zebra 1 signal detection.
Sets the detection value for the zebra 2 signal.
1,2, 1&2
Selects a zebra signal to be displayed on the viewfinder.
1
: Zebra 1 signal
2
: Zebra 2 signal
1&2 : Both zebra 1 and 2 signals are displayed at the same time.
1, 2, [OFF]
Selects a TEST signal to be output in setting each item on the
PREKNEE/ZEBRA page.
1
: Outputs the sawtooth test signal
2
: Outputs the 3-step waveform test signal
OFF : No test signal is output
XXX ([XX])
Adjusts the R-Y color-difference signal level.
XXX ([XX])
Adjusts the B-Y color-difference signal level.
XXX ([XX])
Adjusts the level of the sample pulse to be mixed with the Y signal.
Adjusts the level of the sync pulse to be mixed with the R-Y signal.
Adjusts the level of the sample pulse to be mixed with the B-Y signal.
XXX ([XX])
Adjusts the G signal level.
1, 2, [OFF]
Selects a TEST signal to be output in setting each item on the VTR/CCU page.
1
: Outputs the sawtooth test signal
2
: Outputs the 3-step waveform test signal
OFF : No test signal is output
ON, [OFF]
Turns on and off the camera color-bar signal to be output in setting
each item on the VTR/CCU page.
XXX ([XX])
Adjusts the auto-iris level.
Sets the way the iris is automatically adjusted. -99 (PEAK) ↔ 99 (AVERAGE)
XXX ([XX])
3-1. Setup Menu
3-1-6. System Config Menu
3-15
Advertisement
Table of Contents
