Advanced Settings - Sharp AR-C260P Operation Manual

SELECTING PRINTING FUNCTIONS

Advanced settings

The following screen appears when the Advanced Settings tab is selected. The settings and buttons in this screen
are explained below.
Image Quality
This item is used to select the [Resolution
Settings] and [Graphics Mode] for printing.
[Resolution Settings]
Select 300 dpi or 600 dpi.
Default setting: 600 dpi
[Graphics Mode]
Select [Raster] or [HP-GL/2]. Select [Raster] to
print using raster graphics. Select [HP-GL/2] to
print using HP-GL/2 commands.
Default setting: HP-GL/2
Margin Shift
Use this setting to shift the image to create a
margin at the left, right, or top of the paper. Select
from [None], [10mm.], [20mm.], or [30mm.].
Default setting: None
One-sided copying
Original image
Image shifted
to the right
Margin
2-10
Downloaded from: http://www.usersmanualguide.com/
Image shifted Image shifted
to the left to the bottom
Margin
Two-sided copying
Original image
Image shifted
to the right
Margin
Page Protection
If an error occurs because there is too much print
data, selecting this checkbox may enable printing
to take place. Try selecting this checkbox when a
print error occurs. Note that the printing speed will
be slower. (If only standard memory is installed
(128 MB), this setting cannot be selected.)
Default setting: Not selected
Overlays
Select this setting to print a previously created
form as an overlay on the document. The form
Margin
must have been previously stored.
Default setting: No Overlay
[Edit]
Click this button to open the overlay settings
window. The form selected in this window will be
used for the overlay.
Font
Click this button to change the font settings.
Image shifted Image shifted
to the left to the bottom
Margin
Margin