Sharp AR-C260P Operation Manual page 35

TROUBLESHOOTING
Troubleshooting saddle stitch finisher problems
Problem
Stapling position is not
correct (including
saddle stitch).
The saddle
finisher does
operate. (Plain paper
cannot be printed on.)
Stapling cannot
performed (including
saddle stitch).
Cannot be punched.
The punch
positions are
correct
*2
*2:When a Punch module is installed.
4-4
Downloaded from: http://www.usersmanualguide.com/
Check
Stapling position not set properly?
stitch Are any saddle stitch finisher covers open?
not
Message indicating need to remove paper
from the stapler compiler displayed?
be Has the page limit for stapling been
exceeded?
Message to check the staple unit displayed? Remove jammed staples. (See page 5-5 of the
Message to add staples displayed?
Are different sizes of paper mixed together? Stapling is not possible on mixed sizes of paper.
Is the paper badly curled, preventing
stapling?
*2 Does a checkmark appear in the [Punch]
checkbox in the Main tab?
Mixed paper sizes?
Paper is badly curled and the output paper is
not punched.
Message to check the punch waste box
displayed?
hole The punch function is not set to the correct
not punch positions.
Solution or cause
Check the stapling position setting. (See
and 4-8.)
Close all covers. (See pages 5-7 and 5-8 of the
Operation Manual (for general information).)
Remove all paper remaining in the staple compiler as
explained in step 4 on page 5-5 of the Operation
Manual (for general information). (Be sure to remove
after printing postcards or envelopes.)
Check the page limit (page 2-4)
Operation Manual (for general information).)
Replace the staple cartridge. (See page 5-4 of the
Operation Manual (for general information).)
Check that a staple cartridge has been installed. (See
page 5-4 of the Operation Manual (for general
information).)
Differences in paper quality and type may result in bad
curling of output paper. Take the paper out of the tray
or bypass tray, turn it around, and reload it so that the
top and bottom edges are reversed.
Click the [Punch] checkbox so that a checkmark
appears (page 2-5).
Punching is not possible when different paper sizes are
mixed together.
Differences in paper quality and type may result in bad
curling of output paper. Take the paper out of the tray
or bypass tray, turn it around, and reload it so that the
top and bottom edges are reversed.
Dispose of punch scraps. (See page 5-6 of the
Operation Manual (for general information).)
Check the allowed hole punch positions.
pages 2-4, 4-7
(page 2-5)