Sharp AR-C260P Operation Manual page 34

Problem
Colour documents print
in black and white.
Though selected in the
software application,
colour printing does not
take place.
The colour balance
cannot be adjusted.
Two-sided printing is
not possible. *1
Not all of the image is
printed.
The printer
cannot be installed.
A notice page is printed
at the end of a print job.
Deviations in
specified colours occur,
or colour text is blurred.
*1:When a Duplex module/2 x 500 sheet paper drawer is installed.
Downloaded from: http://www.usersmanualguide.com/
Check
Is the [Color Mode] setting set to [Color] in
the Color tab of the printer driver?
Is the correct printer driver selected in the
software application?
Does the application support colour printing? Read the application manual to see if colour printing is
Is the correct printer driver selected?
Is the [Color Mode] setting set to [Color] or
[Automatic] in the Color tab of the printer
driver?
Is [2-Sided(Book)]
selected in the Main tab of the printer driver?
All multiple applications
open?
Is the page layout too complex?
Is a custom size being used for the "Paper
Size"?
driver Is there sufficient free space on your hard
drive?
Are you running an operating system that is
not supported?
Was the print job sent from the computer
printed correctly?
the Is there a large difference in the tones of the
four colours (cyan, magenta, yellow, and
black)?
Set the [Color Mode] to [Color]
Select the correct printer driver.
supported.
Select the correct printer driver.
Set the [Color Mode] to [Color] or [Automatic]
13).
or [2-Sided(Tablet)] Select [2-Sided(Book)] or [2-Sided(Tablet)]
simultaneously Before printing, close all applications that are not being
used.
Select [Page Protection] in the Advanced tab
10) or simplify the layout.
When using a custom size, the paper must be loaded
horizontally
Delete unneeded files and applications to free up more
space.
Check the "Software Setup Guide (for printer)" to see if
your operating system is supported.
Read the notice page and try printing again, or change
the settings
Perform colour adjustment (see page 13 of the "Key
Operator s Guide").
TROUBLESHOOTING
Solution or cause
(page 2-13).
(page 2-8).
(page 4-6).
(page 2-
(page 2-2).
(page 2-
4-3