Assembly - Beef Eater DISCOVERY 1000 Series Assembly And Operating Instructions Manual

ASSEMBLY

IMPORTANT
It is easier to do all assembly work while components are
lying on their back, so that they do not need to be supported
in the air. Once completed, the assembly can be brought
back upright, leveled and completed.
If choosing to work this way, ensure to remove all loose
items from the different parts, and lay back on a padded,
flat and level surface, not too far from where you wish the
Outdoor Kitchen to stand.
Tools Required for Assembly:
Phillips Head Screwdriver
Step 1
4 x 'B', 4 x 'E', 8 x 'D'
Remove the Hood and all other loose items from inside
barbecue, and place it on its back.
Attached the Heat Shield spacer with 2 short screws to each
side using nuts.
Step 2
4 x 'A', 4 x 'E', 8 x 'D'
Position the 2 cabinets on the sides of the barbecue,
and attach to the barbecue with 2 screws through the 2
remaining free holes in Heat Shield spacer on each side.
Fasten with nuts.
8
ASSEMBLY
Step 3
4 x 'D', 4 x 'B', 1 x 'F'
Connect the base shelf to place.
Once done, stand the whole assembly upright. Fit rubber
grommet.
Step 4
4 x 'C'
Attach the Front Guard.
You may reassemble the Hood, burners, Vaporizers, Grills
and Plates.
Step 5
Cabinet handles should be mounted using the bottom and
middle holes.