Table of Contents
Advertisement
INSTALLATION OPTIONS
Partial Enclosures (Australia Only)
This appliance shall only be used in an above ground, open
air situation with natural ventilation, without stagnant areas,
where gas leakage and products of combustion are rapidly
dispersed by wind and natural convection. Any enclosure
in which the appliance is used shall comply with one of the
following:
Within a partial enclosure that
includes an overhead cover
and no more than two walls.
Before proceeding, you need to establish the gas type which
your barbecue will run on, and the style of installation you
need.
Natural Gas or LPG/Propane.
Before beginning installation or assembly, check that the gas
type which the barbecue is designed for is correct for the gas
available to you. In most countries the choices are natural
gas or LPG/propane. You will find the gas type label on the
side of your barbecue. If your barbecue uses the incorrect
gas type, or if you are unsure, consult your dealer before
going any further. Using the wrong type of gas for a barbecue
is extremely dangerous.
Natural Gas Conversion
Most newly purchased barbecues are made for LPG/
propane. A natural gas conversion kit is available to allow
your barbecue to run on Natural Gas. This kit includes all
hoses required for installation.
16
INSTALLATION OPTIONS
Within a partial enclosure that includes an overhead cover and more than
two walls, the following shall apply:
•
At least 25% of the total wall area is completely open; and
•
at least 30% of the remaining wall area is open and unrestricted.
In the case of balconies, at least 20% of the total of the side, back and front
wall areas shall be and remain open and unrestricted.
Any enclosure with walls
on all sides, but at least
one permanent opening
at ground level, and no
overhead cover.
Advertisement
Table of Contents
