Installation Warnings - Beef Eater 1600 Series Assembly And Operating Instructions Manual

INSTALLATION WARNINGS

WARNING
• This appliance shall only be used in an above ground, open
air situation with natural ventilation without stagnant areas,
where gas leakage and products of combustion are rapidly
dispersed by wind or natural convection. This barbecue has
been designed for outdoor use only. Failure to adhere to
these installation instructions may cause injury or property
damage and affect your ability to make a claim under the
manufacturer's warranty. Refer to diagrams below.
• Never install this barbecue inside any building, garage,
shed or breezeway or inside a boat, caravan or recreational
vehicle. This is to prevent the possibility of fire or carbon
monoxide poisoning or asphyxiation.
• Any enclosure in which this appliance is installed shall
comply with one of the following:
– An enclosure with walls on all sides, but at least one
permanent opening at the ground level and no overhead
covering
– Within a partial enclosure that includes an overhead cover
and no more than 2 walls
– Within a partial enclosure that includes an overhead cover
and more than 2 walls, the following shall apply:
– At least 25% of the total wall area is completely open
and at least 30% of the remaining wall area is open and
unrestricted
• In the case of balconies, at least 20% of the total of the side,
back and front wall areas shall be and remain open and
unrestricted.
Outdoor area example
1
Outdoor area example
2
both ends
open
Outdoor area example
3
Outdoor area example
4
open side at
least 25% of
total wall area
Outdoor area example
5
open side at
least 25% of
total wall area
8
INSTALLATION WARNINGS
Choosing a location
When planning the location and preparing the installation
structure for this appliance note the following:
•
•
•
•
•
•
•
Natural gas requirements
•
Natural gas conversions
Conversion of this unit to natural gas must be carried out by a
qualified licensed person and a Certificate of Compliance must
be issued to the owner on completion of the installation and
conversion. Conversion of this barbecue by unlicensed persons
may result in improper functioning of the appliance, injury,
property damage and may affect your ability to make a claim
under the manufacturer's warranty.
30% or more
in total of the
remaining wall
area is open and
unrestricted
30% or more
in total of the
remaining wall
area is open and
unrestricted
This appliance must be installed in accordance with
Australian Standard AS 5601 and in accordance with local
authority.
Requirements in these instructions for clearances to
combustible materials also apply to combustible materials
that have non-combustible materials attached to their
surface.
The minimum clearance from combustible construction
materials to all sides of the appliance is 450mm.
The minimum clearance to a vertical wall above bench level
that is made from combustible material is 450mm.
The vertical clearance above the cooking surface to any
combustible materials must be at least 1000mm.
When using LPG in an enclosure ventilation must be
provided. Gas is highly explosive and can cause serious
injury and damage to property if allowed to accumulate and
then be ignited.
Avoid windy positions as this will affect cooking
performance and burner efficiency. If this situation cannot
be avoided some shielding may be necessary.
The enclosure must be constructed so that access can be
gained to the natural gas regulator at all times.
WARNING