Commissioning, Inspec-Steps - Commissioning, Inspection And Maintenance - Viessmann Vitodens 222-F Installation And Service Instructions For Contractors

Steps - commissioning, inspection and maintenance
Commissioning steps
Inspection steps
Maintenance steps
•
1. Removing the front panels................................................................................................ 29
•
2. Filling the heating system................................................................................................. 29
•
3. Filling the DHW cylinder on the DHW side...................................................................... 30
•
4. Venting the boiler............................................................................................................... 31
•
5. Filling the trap with water.................................................................................................. 31
•
6. Venting the heating system............................................................................................... 32
•
7. Commissioning the system............................................................................................... 33
• • •
8. Checking all connections on the heating water and DHW sides for leaks
•
9. Designating heating circuits - only for weather-compensated control units.............. 35
• •
10. Checking the gas type....................................................................................................... 35
•
11. Gas type conversion (only for operation with LPG)....................................................... 36
• • •
12. Checking the static pressure and supply pressure........................................................ 36
• 13. Function sequence and possible faults........................................................................... 38
•
14. Setting the max. heating output........................................................................................ 39
•
15. Activating screed drying................................................................................................... 39
•
16. Tightness test on balanced flue system (annular gap check)....................................... 40
•
17. Removing the burner......................................................................................................... 41
• •
18. Checking the burner gasket and burner gauze assembly.............................................. 41
• •
19. Checking and adjusting the ignition and ionisation electrodes.................................... 43
•
20. Cleaning the heating surfaces.......................................................................................... 43
•
21. Checking the condensate drain and cleaning the trap................................................... 43
• •
22. Installing the burner........................................................................................................... 45
• •
23. Checking the neutralising system (if installed)
•
24. Checking the anode connection and anode earth current with an anode tester......... 45
•
25. Draining the boiler on the DHW side................................................................................ 46
•
26. Cleaning the loading cylinder........................................................................................... 47
•
27. Checking and replacing the magnesium anode (if required)......................................... 47
•
28. Re-assembling and filling the loading cylinder............................................................... 48
• • •
29. Checking the expansion vessel and system pressure................................................... 48
•
30. Checking the pre-charge pressure and the DHW expansion vessel (if installed)........ 49
• • •
31. Checking the safety valve function
• • •
32. Checking the firm seating of electrical connections
• • •
33. Checking all gas equipment for tightness at operating pressure................................. 50
• •
34. Checking the combustion quality..................................................................................... 50
• • •
35. Checking the flue system for unrestricted flow and tightness
•
36. Matching the control unit to the heating system............................................................ 51
•
37. Adjusting heating curves.................................................................................................. 51
38. Connecting the control unit to the WLAN network......................................................... 53
•
39. Connecting the control unit to the LON........................................................................... 53
Commissioning, inspection, maintenance
Page
27