Viessmann Vitodens 222-F Installation And Service Instructions For Contractors page 34

Commissioning, inspection, maintenance
Commissioning the system
Menu point
"Energy cockpit"
"Flue system"
(not Vitodens 3xx)
Calling up the commissioning assistant at a later
point
If you need to continue commissioning later, the com-
missioning assistant can be reactivated at any time.
Tap the following buttons:
1. "Menu"
Extended commissioning assistant
Illustration of system components (if available)
Fig. 26
34
(cont.)
Settings and explanations
"ON"
■
The Energy cockpit with various scanning options is displayed.
"OFF"
■
The Energy cockpit is not displayed.
"Single connection"
■
Only one boiler is connected to the flue system.
"Multiple connections"
■
Several boilers are connected to the flue system.
2. "Service"
3. Enter "viservice" password.
4. "Commissioning"
1. Call up the commissioning assistant with "Yes".
A safety instruction is shown on the display.
Note
The extended commissioning assistant can be
skipped with "No".
2. After successfully reviewing the safety instruction,
tap "Yes" to confirm. This starts detection of the
connected sensors and the system components
connected via KM-BUS.
This process may take some time.
3. After detecting the devices, tap "Next".
A list of detected system components (device list)
appears on the display.
4. Compare the device list with the system compo-
nents actually connected.
If any components were not detected, these can be
added later via the relevant parameters.
5. Accept the device list with "Next".
A system scheme according to the detected com-
ponents appears on the display.
6. Confirm the system scheme with "Next".
Add or remove system components with
"Change".
■ If there is no heating circuit without mixer in the
system, it must be removed manually.
A second DHW cylinder must be added man-
■
ually.