Replacement Of Mains Cable/Cable Winder - Siemens MOBILETT Plus Service Instructions Manual

Miscellaneous
Fig. 2

Replacement of mains cable/cable winder

•
Remove side covers and the cover with the cassette compartment.
•
Remove the four (two on each side) screws that fixes the cable winder assembly
(pos. 1 / Fig. 2).
CAUTION
•
Pull out the cable winder assembly approximately 10 cm.
•
Disconnect main switch plug K52 (pos. 1 / Fig. 3).
Siemens-Elema AB
Solna, Sweden
1
MOB00618
Sharp edge!
The brake handle could be damaged.
Lock the brake handle, otherwise it is damaged by the sharp
upper edge of the cable winder assembly.
Fig. 3
SPR8-215.898.02
Rev. 01 01.02
Page 3 of 6 MOBILETT Plus/ Plus E
SPS-UD
8 - 3
1
8