Adjustment Of The Hand/ Parking Brake - Siemens MOBILETT Plus Service Instructions Manual

10 - 22
3
Fig. 22

Adjustment of the hand/ parking brake

DANGER
Equipment required: Spring scale
•
Disconnect the unit from the wall outlet.
•
Block up the unit on both sides with 5 x 5 cm pieces of wood. The wheels must be able to
rotate independently.
•
Remove the rear wheel by removing the screw.
•
Check the brake linings. If the brake linings are thinner than 1 mm, they must be replaced
(Fig. 22).
•
Remove the old lining by loosening screw (pos. 1 / Fig. 22).
•
When installing the new lining, make sure that the lining is facing the right way.
•
If the braking linings meet the requirements and the braking force is still low, check the
tension of the brake wire.
•
Remount the rear wheels.
MOBILETT Plus/ Plus E
2
Never work with the system open if the capacitor is charging or
has just been charged.
The capacitor bank may still be charged even if the system is
switched OFF and the mains cable is disconnected.
Life-threatening electric shock hazard exists.
See Chap.:
"Protective measures when working on the capacitor bank".
SPR8-215.898.02
Rev. 01 01.02
Mechanical systems
1
Page 22 of 28 Siemens-Elema AB
SPS-UD
> 1 mm
10
Solna, Sweden