Adjusting The Handlebar Position - Husqvarna TE 250i 2022 Owner's Manual

11.16

Adjusting the handlebar position

Warning
Danger of accidents A repaired handlebar poses a safety risk.
If the handlebar is bent or straightened, the material becomes fatigued. The handlebar may break as a
result.
–
Change the handlebar if the handlebar is damaged or bent.
The handlebar can be mounted in four different positions. This
allows the handlebar to be mounted in the most comfortable
position for the rider.
–
Remove screws
the handlebar and lay it to one side.
Info
Cover the components to protect them against dam-
age.
Do not kink the cables and lines.
–
Remove screws
–
B00375-10 Place the handlebar supports in the required position. Mount
and tighten screws
Guideline
Screw, handle-
bar support
Info
Position the left and right handlebar supports evenly.
–
Position the handlebar.
Info
Make sure the cables and wiring are positioned cor-
rectly.
–
Position the handlebar clamps. Mount screws
evenly.
Guideline
Screw, handlebar
clamp
Info
Make sure the gap widths are even.
TUNING THE CHASSIS 11
1
. Take off the handlebar clamps. Remove
2
. Take off the handlebar supports.
2
.
M10 40 Nm (29.5 lbf ft)
M8 20 Nm (14.8 lbf ft)
®
Loctite 243™
1
and tighten
55