Running In The Engine - Husqvarna TE 250i 2022 Owner's Manual

8 PREPARING FOR USE
–
Adjust the basic position of the hand brake lever. (
–
Adjust the basic position of the foot brake lever.
–
Adjust the basic position of the shift lever.
–
Get used to the handling characteristics of the motorcycle on a suitable surface before undertaking more
challenging trips.
–
Try also to ride as slowly as possible and in a standing position to get a better feel for the motorcycle.
–
Do not make any off-road trips that exceed your ability and experience.
–
Hold the handlebar firmly with both hands and keep your feet on the footrests when riding.
–
If you carry luggage, make sure you secure it firmly as close as possible to the center of the vehicle and
ensure even weight distribution between the front and rear wheels.
–
The maximum permissible overall weight and the maximum permissible axle loads must not be exceeded.
Guideline
Maximum permissible overall weight
Maximum permissible front axle load
Maximum permissible rear axle load
–
Check the spoke tension. (
–
Run the engine in. (
8.2
–
During the running-in phase, do not exceed the specified engine performance.
Guideline
Maximum engine performance
–
Avoid fully opening the throttle!
–
Check the idle speed regularly.
Guideline
Idle speed
»
32
Info
When offroad, it is recommended that you are accompanied by another person on another vehicle
so that you can help each other.
Info
Motorcycles react sensitively to any changes of weight distribution.
p. 103)
Info
The spoke tension must be checked after half an hour of operation.
p. 32)

Running in the engine

During the first 3 operating hours
During the first 5 operating hours
Info
The idle speed may change during the run-in time.
If the idle speed changes:
–
Adjust the idle speed.
p. 87)
( p. 93)
( p. 128)
335 kg (739 lb.)
145 kg (320 lb.)
190 kg (419 lb.)
< 70 %
< 100 %
1,400 ... 1,500 rpm
( p. 126)