Table of Contents
Advertisement
12.40
Checking the rubber grip
12.41
Adjusting the basic position of the clutch lever
SERVICE WORK ON THE CHASSIS 12
Finishing work
–
Install the fuel tank.
–
Install the right side cover. (
–
Mount the seat. (
–
Install the air filter box cover. (
–
Check the rubber grips on the handlebar for damage, wear,
and looseness.
Info
The rubber grips are vulcanized onto a sleeve on the
left and onto the handle tube of the throttle grip on the
right. The left sleeve is clamped onto the handlebar.
The rubber grip can only be replaced with the sleeve
or the throttle tube.
401197-01
»
If a rubber grip is damaged or worn:
–
Change the rubber grip.
–
Check that screw
Guideline
Screw, fixed
grip
A
Diamond
figure.
S04838-10
–
Adjust the basic position of the clutch lever to your hand size
by turning adjusting screw
Info
When the adjusting screw is turned counterclockwise,
the clutch lever moves away from the handlebar.
When the adjusting screw is turned clockwise, the
clutch lever moves closer to the handlebar.
The range of adjustment is limited.
Turn the adjusting screw by hand only, and do not
S04405-11
apply any force.
Do not make any adjustments while riding.
(
p. 75)
p. 73)
p. 68)
p. 69)
1
is firmly seated.
M4
5 Nm (3.7 lbf ft)
must be positioned visibly as shown in the
1
.
®
Loctite
243™
83
Advertisement
Table of Contents
