Mounting And Connecting The Synergy Manager And Synergy Units - SolarEdge Se K Series Installation Manual

Mounting and Connecting the Synergy Manager and
Synergy Units
This section provides instructions for vertical installation of the inverter and horizontal
Inverter installed horizontally on a flat surface.
NOTE
Make sure the mounting surface or structure can support the weight of 82 kg
(for inverter with two Synergy Units) or 114 kg (for inverter with three Synergy
Units) of the inverter and brackets. Make sure that the mounting surface is at
least 116.8 cm x 100.8 cm.
CAUTION!
HEAVY OBJECT. To avoid muscle strain or back injury, use proper lifting
techniques, and if required - a lifting aid.
CAUTION!
SolarEdge inverters and Power Optimizers can be installed at a minimum
distance of 50 m/ 164 ft from the shoreline of an ocean or other saline
environment, as long as there are no direct salt water splashes on the inverter or
Power Optimizer.
For SolarEdge inverters installed at a distance of 200 m / 655 ft or closer to the
shoreline, special brackets purchased separately from SolarEdge and SS304
stainless screws are required.
To mount the inverter:
1. Determine the inverter mounting location on a wall or stud framing. It is
recommended to mount the inverter in a location protected from direct sunlight.
NOTE
When installing the inverter on a stud framing or a rail, avoid wobbly
installation by adding back support at the lower back side of the Synergy
Manager and Synergy Units (See Figure 12 )
2. Allow for proper heat dissipation, follow the guidelines specified in
Note - Clearance Guidelines
NOTE
Some Inverter models are provided with only two Synergy Units.
3. Level the mounting template horizontally against the wall and mark the drilling hole
locations for the bracket of the Synergy Units (see pencil icons in Figure 12 ).
Three Phase Inverter with Synergy Technology P/N: SExxK-xxxxIxxxx SExxK-xxxxIxxxx
Chapter 3: Installing the Synergy Manager and Synergy Units
.
30
Application