Advertisement
14
www.raider.bg
5. Set the container on a sheet of paper, pour in the prepared coating material and screw the
container tightly onto the spray gun.
6. Put the machine down only on a level, clean surface. Otherwise the machine could suck in
dust, etc.
7. Hang the machine on your shoulder with the carrying belt.
8. Take the spray gun out of the spray gun holder and point it at the target object.
9. Push the ON / OFF switch on the machine.
IV. Spray Technique.
The spray result depends heavily on the smoothness and cleanliness of the surface to be
sprayed. Therefore the surface should be carefully prepared and kept free of dust. Cover all
surfaces not to be sprayed. Cover screw threads or similar parts of the target object. It is
advisable to test the spray gun on cardboard or a similar surface to find the correct setting.
Important: Begin spraying outside of the target area and avoid interruptions inside the target
area. An even movement of the spray gun results in an even surface quality.
V. Taking Out of Operation and Cleaning.
1. Turn the machine off. Activate the trigger guard so that the coating material in the spray gun
flows back into the container.
2. Unscrew the container. Empty any remaining coating material back into the material tin.
3. Pre-clean the container and feed tube with a brush.
4. Pour solvent or water into the container. Screw the container back on.
Use only solvents with a flashpoint over 21°C
Advertisement
