Making Further Cups Of Coffee - ARIETE Cialdissima mp50 Manual

hOW TO MAke cAppuccInO
To prepare a cappuccino or hot chocolate or to heat any other beverage, press the switch (N); the indicator lamp (O) will
turn on to show that the steam function has been turned on. When the lamp (R) turns on, the machine is ready to generate
steam.
If small puffs of steam come out of the coffee dispensing spout while you are waiting for the steam, this phenom-
enon is to be considered absolutely normal.
Turn the steam dispensing cock (C), having the foresight to position a cup underneath the Maxi Cappuccino device (H) Fig. 10:
at first a little water will come out, immediately followed by a strong jet of steam.
Close the steam cock (C) and put the pot of milk to be whipped underneath the Maxi Cappuccino device. Plunge the stylus
all the way into the pot of milk (Fig. 11) and again turn the dispensing cock (C) until you get the result you want. During these
operations you may notice that the warning light (R) goes on and off from time to time, indicating that the boiler thermostat
is keeping the water required for the steam supply at the right temperature.
It is opportune you start dispensing the steam only when this indicator lamp is on. Dispense the steam for a few
seconds after every use in order to free the hole of any milk residue.
After the cappuccino is prepared, press the switch (N) to cut out the steam function.

MAkIng furTher cups Of cOffee

Warning!
Steam is still inside the boiler! Even if you have turned off the steam function, do not turn the cock (C): There is a
danger of burns causes by squirts of hot water and steam that might come out of the cappuccino maker.
To prepare a cup of coffee right after making cappuccino, it is necessary to bring the boiler back to the coffee preparation
temperature by performing these operations: press the steam function switch (N). You may notice that the indicator lamp
(R) is on. This luminous indication serves to tell you that the temperature in the boiler is still high, i.e. it is still that for steam;
you must therefore wait a few seconds until the lamp (R) turns off. Wait until the lamp (R) turns back on before dispensing
the coffee.
To speed up the boiler cooling process, all you have to do is put a cup underneath the dispensing spout (G) and press the
button (Q) to make hot water come out of the spout, thus lowering the boiler temperature.
Warning!
Do not touch the hot water coming out of the spout; danger of burns.
It is advisable to remove the pod previously used before dispensing hot water from the spout.
Warning!
Little puffs of steam may come out of the closed pod holder while dispensing. This phenomenon is to be considered
absolutely normal.
hOW TO MAke TeA Or TIsAnes
When the machine is in the coffee-ready position, i.e. with the lamp (R) on, place a cup underneath the spout (H) and press
the coffee dispensing switch (Q). Open the steam dispensing cock (C) immediately afterwards; in this way hot water will
come out of the spout. The maximum quantity for two cups is 200 ml.
13