VERDER PACKO ZL Series Operation & Maintenance Manual page 29

8.
Or pull out the drive & idle shafts by hitting with a soft mallet
the rear-end of each shaft on the gasket face of the Gearbox.
9. Remove the bearings and spacers (16) together from the
shafts by pressing the shaft out of them. Or remove bearings
by puller shown in Figure 36.
10. The taper roller bearings for ZL400 series must be kept
together with in-outside spacer and separate for drive & idle
shafts.
Fig. 35
Fig. 36
Fig. 37
27