Installing The Glass Shades And Light Bulbs - Emerson PRO CF710BS03 Owner's Manual

11. Installing the Glass Shades and Light Bulbs

11.1
To Install the Glass Shade: Squeeze the Retaining
Clips towards the Bulb Socket and Slide on the Glass
Shade (Figure 25). The Spring Clips will Seat the
Shade and Secure it in place.
Install a 9.5-Watt Medium Base LED Bulb in each of the
Light Fitter Sockets (Figure 25).
To Remove the Shade: First Remove the Light Bulb
from the Socket, then simply Pull the Shade off using a
Twisting Motion.
12. Removal of the Light Fixture
12.1
NOTE: In some instances it may be desirable to
install the ceiling fan without the light fixture. If this
is the case, proceed as follows. (You may want to
keep the light fixture for possible future use.)
Light bulbs and glass shades removed.
Remove the Three Switch Housing Screws securing
the Light Fixture (Figure 26).
Retain the Three Switch Housing Screws for Future
Use.
12.2
Disconnect the Two Wire Connectors that are securing
the Light Fixture Wires to the Switch Housing Wires
(Figure 27).
Retain the Wire Connectors for Future Use.
SQUEEZE
RETAINING
CLIPS
TOGETHER
AND SLIDE
ON GLASS
SHADE
Figure 25
SCREW (3)
Figure 26
Figure 27
17
Please contact 1-800-654-3545 for further assistance
RETAINING
CLIP
9.5-WATT MEDIUM
BASE LED BULB
(3 or 4)
GLASS
SHADE
SWITCH
HOUSING
LIGHT
FIXTURE
LIGHT BULBS
PREVIOUSLY
REMOVED
SWITCH
HOUSING
REMOVE THE TWO
WIRE CONNECTORS
TO DISCONNECT
WIRES FROM LIGHT
FIXTURE AND THE
SWITCH HOUSING
LIGHT
FIXTURE
emersonfans.com
U.L. Model No.: 42-ANT & 52-ANT