Troubleshooting,
Error messages on
the remote control's
LCD panel
PC-Tool
Reset the unit after
a restart
36
continued
Errors are displayed on the HRC3 remote control with an "E" + a number.
The error can then be looked up in the troubleshooting overview and in the manual for
the remote control in the chapter for rectifying errors.
Operating warnings and errors are logged in the controller's memory. Connect a com-
puter with PC-Tool installed via USB to output detailed information from the logfile.
A restart of the unit (disconnect/connect 230V) will reset the controller and start the
unit up in standard operating mode.
The controller will subsequently check for any errors. This can take up to 15 minutes.