Table of Contents
Advertisement
Spectral M800 Q4 IP
Strobe Settings
In this menu you can choose the desired strobe mode.
01) Press the UP/DOWN buttons until the display shows
02) Press the ENTER button to open the menu.
03) Press the UP/DOWN buttons to toggle between the following 2 options:
Special strobe
Classic strobe
PWM
In this submenu you can set the PWM (Pulse Width Modulation) frequency.
01) Press the UP/DOWN buttons until the display shows
02) Press the ENTER button to open the submenu.
03) Press the UP/DOWN buttons to choose the desired PWM frequency. The available options are: 600 Hz,
1200 Hz, 2000 Hz, 2400 Hz, 4000 Hz, 6000 Hz and 25000 Hz.
Note:
The higher the PWM frequency, the lower the dimmer's grayscale.
Calibration
In this menu you can adjust the characteristics of the white color or set the RGB calibration.
01) Press the UP/DOWN buttons until the display shows
02) Press the ENTER button to open the menu.
03) Insert the password: UP>DOWN>UP>DOWN and press the ENTER button to confirm.
04) Press the UP/DOWN buttons until the display shows one of the following 3 options:
White color calibration
RGB calibration
Calibration reset
White Color Calibration
In this menu you can adjust the temperature of the built-in white color presets.
01) When the display shows
02) Press the UP/DOWN buttons to choose one of the 11 white color presets: WH.01–11.
03) Press the ENTER button to open the submenu.
04) Press the ENTER button to toggle through RED, GREEN, BLUE and WHITE.
05) Press the UP/DOWN buttons to set the color intensity. The adjustment range of each color is 0–255,
from OFF to FULL ON.
Product code: 43571
, press the ENTER button to open the menu.
34
.
.
.
Advertisement
Table of Contents
