Page 1
44.2ST E/HY Electric/Hydraulic Two-Speed Self-Tailing Winch Winch Parts Installation Service Required Tools Screwdriver Plastic Head Hammer or Mallet Small Knife Brush Rags Solvent Grease Parts List Pawl Pawl Spring Washer 6009 Screw 6047 Screw 6144 Screw 6284 Gasket 6310 Screw 6481 Washer 6663...
Page 2
Remove Winch Handle Socket Screw Drive Position IMPORTANT: Note position of winch Drive Gear in relation to Loosen in Handle Socket using disconnet rod flathead screwdriver, as shown below. Mounting Base and mark on Base. Position winch so sheet enters drum at Drive Gear. Drive Gear Position drive gear where...
Page 3
Disconnect rod must disconnect gearbox when lock-in winch handle is inserted in Handle Socket. Service winch before the sailing season begins and once during Minimum/Maximum Line Diameter Harken winches feature spring-loaded self-tailing jaws which adjust automatically to the following line sizes: 5 /16" (8 mm) Minimum 1 /2"...
Page 4
1251 E. Wisconsin Ave., Pewaukee, WI 53072 USA • Tel: (262) 691-3320 • Fax: (262) 691-3008 • Web: www.harken.com • Email: harken@harken.com Via della Cerca, 12/14, 22070 Lurago Marinone (CO) Italy • Tel: (39) 031.3523511 • Fax: (39) 031.3520031 • Web: www.harken.it • Email: info@harken.it...