Ssd Slots; Install An Ssd In A Removable Disk Enclosure - Datavideo HDR-90 Instruction Manual

3.

SSD Slots

The SSD slots are located on the front panel.
The SSD must be installed in a removable disk enclosure (see
Removable Disk Enclosure) before inserting into SSD slots. After disk insertion, make sure
the drive is locked to avoid unintentional disk removal. Move the latch to the LOCK position.
To remove the disk, unlock the drive then pull the disk out of the slot.
The slot LED indicators show disk status of SSD slots
1 and 2 respectively. Solid green light indicates
normal disk function and flashing red light indicates
that the HDR unit is accessing the disk. The LED will
be off if no disk is inserted.
Note: HDR-90 only accepts Samsung 860 Pro SSD.

3.1 Install an SSD in a Removable Disk Enclosure

If your unit was delivered without a hard drive inserted, please follow the steps below to
insert the hard disk into a drive enclosure before inserting into the HDR.
Install an SSD drive in a
1. Remove the four screws on two sides of
the SSD disk enclosure then lift the top plate.
13