Perkins 400 Series Operation And Maintenance Manual page 28

28
Operation Section
Engine Storage
11. Remove the fuel injectors and spray 1762811
POWERPART Lay-Up 2 for one or two seconds
into each cylinder bore with the piston at BDC.
12. Slowly rotate the crankshaft for one complete
revolution and then replace the fuel injectors.
Induction System
• Remove the air filter assembly. If necessary,
remove the pipes that are installed between the air
filter assembly and the turbocharger. Spray
1762811 POWERPART Lay-Up 2 into the
turbocharger. The duration of the spray is printed
on the container. Seal the turbocharger with
waterproof tape.
Exhaust System
• Remove the exhaust pipe. Spray 1762811
POWERPART Lay-Up 2 into the turbocharger.
The duration of the spray is printed on the
container. Seal the turbocharger with waterproof
tape.
General Items
• If the lubricating oil filler is installed on the valve
mechanism cover, remove the filler cap. If the
lubricating oil filler cap is not installed on the valve
mechanism cover, remove the valve mechanism
cover. Spray 1762811 POWERPART Lay-Up 2
around the rocker shaft assembly. Replace the
filler cap or the valve mechanism cover.
• Seal the vent of the fuel tank or the fuel filler cap
with waterproof tape.
• Remove the alternator drive belts and put the drive
belts into storage.
• In order to prevent corrosion, spray the engine
with 1734115 POWERPART Lay-Up 3 . Do not
spray the area inside the alternator.
When the engine protection has been completed in
accordance with these instructions, this ensures that
no corrosion will occur. Perkins are not responsible
for damage which may occur when an engine is in
storage after a period in service.
Your Perkins dealer or your Perkins distributor can
assist in preparing the engine for extended storage
periods.
SEBU7992-05