Inspection; Hook Dimensions And Specifications - R&M LOADMATE LM05 II Series Installation And Maintenance Manual

LM05 SERIES II I&M MANUAL/EN/11.30.2010

7.9.2 Inspection

Inspection for wear on top hook and load hook SHALL be checked routinely. Measure the throat opening.
(dimension-a2). If throat opening exceeds maximum opening allowed, replace hook.
latches SHALL be replaced immediately.
Maximum allowed throat opening:
Hook Class:
Maximum allowed opening:

7.9.3 Hook Dimensions and Specifications

Figure 18. Hook Dimensions
Table 4. Hook Dimensions
CAP CAP TEST
FALLS
TON KG LBS
¼ 250 1102 1
1
½ 500 2205
2
1 1000 4410 1
Mark:
DIN model number:
DIN 15400 Class:
DIN 15401 Material:
This document and the information contained herein, is the exclusive property of R&M Materials Handling, Inc., and represents a non-public, confidential and proprietary trade secret that
may not be reproduced, disclosed to third parties, altered or otherwise employed in any manner whatsoever without the express written consent of R&M Materials Handling, Inc.
Copyright © (2010) R&M Materials Handling, Inc. All rights reserved.
012T load hook
0.905" [23 mm]
HOOK
øM øa1
CLASS
0.551 1.181 0.787
012T
[14] [30]
0.551 1.181 0.787
012T
[14] [30]
0.630 1.417 1.024
025T
[16] [36]
0.630 1.417 1.024
025T
[16] [36]
ISO 2766
15401
T
35 CD 4
025T load hook
1.181" [30 mm]
DIMENSIONS - INCH / [mm]
a2 a3 b1 b2
1.339 0.748 0.591
[20] [34] [19] [15]
1.339 0.748 0.591
[20] [34] [19] [15]
1.614 0.866 0.748
[26] [41] [22] [19]
1.614 0.866 0.748
[26] [41] [22] [19]
Damaged safety
top hook
1.456"[37mm]
e1 h1 h2 t1
3.268 0.866 0.748 1.260
[83] [22] [19] [32]
3.268 0.866 0.748 1.260
[83] [22] [19] [32]
3.780 1.102 0.945 1.496
[96] [28] [24] [38]
3.780 1.102 0.945 1.496
[96] [28] [24] [38]
t2
0.394
[10]
0.394
[10]
0.512
[13]
0.512
[13]
41/89