Turbofiller Rinsing; Boomprime (Optional) - Hardi NAVIGATOR PRO Original Instruction Book

TurboFiller rinsing

Rinsing the TurboFiller and chemical containers are done in the
following two ways:
When TurboFiller lid is open
For cleaning empty containers. Put container over the rotating flushing
nozzle in the middle of the TurboFiller so that the nozzle is inside the
container. Press the Chemical Container Cleaning lever and the
TurboFiller suction valve at the same time to activate the flushing nozzle
in the middle of the TurboFiller and empty out the TurboFiller rinsing
liquid.
When TurboFiller lid is closed
Use the Chemical Container Cleaning lever to rinse the hopper after filling of chemicals has ended. Press the Chemical
Container Cleaning lever and the TurboFiller suction valve at the same time to activate the flushing nozzle in the middle of
the TurboFiller and empty out the TurboFiller rinsing liquid. Do this 3 times and after the last flushing open the lid to inspect
if the TurboFiller is empty. If not, close the lid again and press the TurboFiller suction valve until the TurboFiller is empty.
μ
ATTENTION! The TurboFiller needs to be cleaned thoroughly after finishing spraying again to be sure it is clean before
spraying other crops that may be sensitive to the chemicals just used. See section "Cleaning" on page 67 for details.

BoomPrime (optional)

The BoomPrime system works automatically, and is activated when a spray job is prepared:
1. Unfold the boom and turn on the P.T.O.
2. Set pressure SmartValve to "Spraying", suction valve to "Main tank"
and agitation valve to "Agitation".
3. Adjust the spray pressure to what will be used when spraying.
4. The boom will then be fully primed within 1-2 minutes.
If the nozzles start to leak when closing one or more sections during a
spray job, do as follows in mentioned order:
A. Adjust the pressure on the BoomPrime pressure regulation.
B. Turn Pressure SmartValve to "Main tank".
C. Disconnect the P.T.O.
If adjustment of the BoomPrime system might be necessary, please refer to "BoomPrime adjustment (optional)" on page 46.
5 - Operation
65