Table of Contents
Advertisement
Interface selection
• Standard USB only
• Ethernet/Wi-Fi only
• USB-A - Device Charging only
• Enable all the interfaces (initial setting)
Column emulation mode
• 48/35 characters mode (standard mode) (initial setting)
• 42/32 characters mode
Command execution during offline
• Enabled (initial settings)
• Disabled
Amount of top margin by backfeed
• 2.0mm
• 9.5mm (no backfeed) (initial settings)
• When using the backfeed function with the printer that has been set up to eject paper from the
top side, remove any paper ejected from the ejection slot before starting printing.
• Disable the automatic top logo setting when enabling backfeed.
• Even if the "backfeed" has been enabled, it is not performed during the self-test.
• If setting a top margin of 5 mm {0.2"} or less, confirm that no errors occur in your environment of
usage. Usage in a hot and humid environment or usage of paper that curls easily may increase
the risk of paper jams.
• When the paper is fed backward, the paper may get wrinkled or smeared due to a slack in the
roll. It is recommended to use thermal paper that has high resistance to abrasion.
• Make sure to feed the paper by at least 20 mm before moving the auto cutter. It the paper feed
length is not enough, it may cause a paper jam.
You can specify values in 0.5mm steps if you use TM-m30II Utility or TM Utility for iOS/Android.
Interface switch waiting time
Select from 1 to 10 seconds (in intervals of 1 second)
1 second (initial setting)
Chapter 3 Advanced Usage
52
Advertisement
Table of Contents
