Table of Contents
Advertisement
Paper
Power
Error
LED
LED
LED
N
F
F
O
F
O
F *4
N
F *5
O
*1: To detect this status (remaining amount of roll paper is low), enable the "Roll paper near-end detection"
function. For more details, see
width roll paper and only when the printer has been set up to eject printed paper from the front side. For more
details about the restrictions, see
*2: The Error LED flashing pattern is: turning on and off alternately at 320 ms intervals for five seconds, then
goes off.
*3: The Power LED flashing pattern is: lighting for 160 ms followed by a pause for 4960 ms.
*4: The Power LED flashing pattern is: lighting for 320 ms followed by a pause for 320 ms.
*5: The Power LED flashing pattern is: lighting for 160 ms followed by a pause for 2400 ms.
Wi-Fi
Ethernet
LED
LED
-
O
O
O
O
O
F
O
O
O
O
O
O
O
O
"Software Settings" on page
"Enabling the Roll Paper Near-End Detection" on page
Chapter 1 Product Overview
LED
Printer Status
Unrecoverable Errors
O
CAUTION:
Turn off the power immediately when
an unrecoverable error occurs.
If the same error occurs again even after
turning the power back on, contact
qualified service personnel.
Updating firmware
O
While forced updating firmware mode is
O
on
During turn-off process
O
During power off
O
NOTE:
The printer enters this status while
processing the power off command. It is
recommended to use this method
when you need to save information on
the printer's operating status if the
power is cut without using the power
switch.
48. This function can be used only with a 80-mm
47.
21
Advertisement
Table of Contents
