Table of Contents
Advertisement
6 - Maintenance
Service and Maintenance intervals
10 hours service - Suction filter
To service the suction filter:
1. Pull out the steel clip (A).
2. Lift the suction hose fitting (B) from housing.
3. Filter guide and filter (C) can now be removed.
To reassemble:
4. Press the guide onto filter end.
5. Place the filter into housing with guide facing up.
6. Ensure the O-ring (D) on the hose fitting is in good condition and
lubricated.
7. Refit the suction hose (B) and steel clip (A).
10 hours service - In-Line filter (optional equipment)
If the boom is equipped with In-Line Filters unscrew the filter bowl
to inspect and clean the filter. When reassembling the O-ring should
be greased.
Alternative filter meshes are available. See section on Technical spe-
cifications - Filters and nozzles.
10 hours service - Nozzle filters
Check and clean.
10 hours service - Spraying circuit
Fill with clean water, operate all functions and check for leaks using higher spray pressure than normal. Check nozzle
spray patterns visually using clean water.
6.3
Advertisement
Table of Contents
