Table of Contents
Advertisement
6 - Maintenance
50 hours service - Transmission shaft
Check function and condition of the transmission shaft protection guard. Replace possible damaged parts.
50 hours service - Wheel bolts and nuts
Tighten wheel bolts and nuts as follows with following torque
wrench settings:
Wheel hub to rim plate: 490 Nm (362 lbft)
Tightening sequence: See illustration and tighten in order of num-
bering.
ATTENTION! When wheels has been mounted or re-tightened,
the plastic nut covers must be placed on the nuts afterwards.
50 hours service - Tyre pressure
Check the tyre pressure according to the table in "Technical specifications".
DANGER! Never inflate tyres more than to the pressure specified in the table. Over-inflated tyres can explode and
cause severe personal injuries! See the part "Occasional maintenance - Change of tyre".
WARNING! If renewing tyres always use tyres with min. load index as specified.
250 hours service - Readjustment of the boom
See section "Occasional maintenance".
250 hours service - Hydraulic circuit
Check the hydraulic circuit for leaks and repair if any.
WARNING! Hoses for boom lifting device must be changed after every 5 years of use.
250 hours service - Hoses and tubes
Check all hoses and tubes for possible damages and proper attachment. Renew damaged hoses or tubes.
6.4
Advertisement
Table of Contents
