Manufacturer's Warranty - Hilti BX 3-ME Original Operating Instructions

Hide thumbs Also See for BX 3-ME:
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 21
Trouble or fault
The spring element is not ten-
sioned and the status indica-
tor blinks red.
The spring element is not ten-
sioned and the status indica-
tor lights red.
The fastener guide cannot
be pressed in and the status
indicator lights green.
The fastener guide is jammed
in the pressed-in state.
10
Disposal
Most of the materials from which Hilti tools and appliances are manufactured can be recycled. The
materials must be correctly separated before they can be recycled. In many countries, your old tools,
machines or appliances can be returned to Hilti for recycling. Ask Hilti Service or your Hilti representative
for further information.
Battery disposal
Improper disposal of batteries can result in health hazards from leaking gases or fluids.
▶ DO NOT send batteries through the mail!
▶ Cover the terminals with a non-conductive material (such as electrical tape) to prevent short circuiting.
▶ Dispose of your battery out of the reach of children.
▶ Dispose of the battery at your Hilti Store, or consult your local governmental garbage disposal or public
health and safety resources for disposal instructions.
▶ Do not dispose of power tools, electronic equipment or batteries as household waste!
11
RoHS (Restriction of Hazardous Substances)
Click on the link to go to the table of hazardous substances: qr.hilti.com/r8843642.
There is a link to the RoHS table, in the form of a QR code, at the end of this document.
12

Manufacturer's warranty

▶ Please contact your local Hilti representative if you have questions about the warranty conditions.
28
English
Printed: 19.07.2018 | Doc-Nr: PUB / 5377483 / 000 / 02
Possible cause
The fastener guide is not fitted
correctly.
System fault.
The magazine is empty.
The nail pusher is jammed.
Nail jammed in the fastener guide.
Dirt between the fastener guide
and the nosepiece.
Action to be taken
▶ Insert the fastener guide.
→ page 23
▶ Remove the battery. → page 23
▶ Insert the battery. → page 23
▶ Load the magazine. → page 24
▶ Remove the nail strips from
the magazine and clean the
magazine.
▶ Release the jammed nail.
→ page 26
▶ Clean the inside of the nose-
piece. → page 27
2184328
*2184328*

Advertisement

Table of Contents
loading

Table of Contents