Manufacturer's Warranty; Further Information - Hilti DX 9-ENP Manual

Trouble or fault
Base plate cannot be
screwed fully into place.
The tool cannot be pressed
fully against the working sur-
face
9 Disposal
Most of the materials from which Hilti tools and appliances are manufactured can be recycled. The
materials must be correctly separated before they can be recycled. In many countries, your old tools,
machines or appliances can be returned to Hilti for recycling. Ask Hilti Service or your Hilti representative
for further information.
10

Manufacturer's warranty

▶ Please contact your local Hilti representative if you have questions about the warranty conditions.
11 FCC statement (applicable in US) / IC statement (applicable in Canada)
This device complies with Part 15 of the FCC Rules and RSS-210 of lC. Operation is subject to the following
two conditions:
1. this device may not cause harmful interference, and
2. this device must accept any interference received, including interference that may cause undesired
operation.
12

Further information

For more information on operation,
qr.hilti.com/manual?id=2194400&id=2194029
This link is also to be found at the end of the documentation, in the form of a QR code.
Notice d'utilisation originale
1 Indications relatives au mode d'emploi
1.1 À propos de ce mode d'emploi
• Avant de mettre l'appareil en marche, lire impérativement ce mode d'emploi.
préalablement requise pour assurer la sécurité du travail et un maniement sans perturbations.
• Bien respecter les consignes de sécurité et les avertissements du présent mode d'emploi ainsi que celles
figurant sur le produit.
• Toujours conserver le mode d'emploi à proximité du produit et uniquement transmettre le produit à des
tiers accompagné de ce mode d'emploi.
*2194400*
Possible cause
The piston guide is clogged with
dirt behind the connecting thread.
The rotating sleeve is not fully
closed.
The nail detector is jammed.
Part of the nail detector is broken.
No fasteners loaded in the tool
technology,
2194400
Action to be taken
▶ Clean the piston guide.
▶ Lubricate the connecting
thread.
▶ Close the rotating sleeve.
→ page 11
▶ Clean the base plate and
remove all foreign objects.
Take care to ensure adequate
lubrication of the fastener strip
guides with Hilti lubricant spray.
▶ Check for correct operation of
the nail detector by checking
that the tool is ready for use
→ page 9.
▶ Load the tool with fasteners.
environment and recycling, follow this link:
C'est la condition
Français 19