Table 9: Status Button Functions - Geokon GeoNet 8900 Series Instruction Manual

22 | NETWORK INSTALLATION | GEOKON
When the Status button is pressed on a Node, the LEDs briefly display the radio
signal status. The Node will indicate the status of the radio signal after each
radio transmission for a period of 10 minutes. If a Node has not yet joined the
network, it will change its radio interval to approximately one second and search
for an available network.
Device Function
Supervisor or Node Reset
Cellular Supervisor & Put the network into Deployment mode/extend Deployment
Mesh Supervisor mode. Display the current status.
Cellular Supervisor Take a reading and send existing data immediately
Display the current status, then indicate signal strength
Node
every radio cycle for 10 minutes

TABLE 9: Status Button Functions

9:
Status Button Action
Press and hold until both LEDs
illuminate (~10 seconds)
Press and release
Press and release
Press and release