Eight-Channel Gland Seal (890X-Xx-08C-Cbl); Additional Information; Tiltmeter Nodes; Table 4: Eight-Channel Node Gauge/Load Limits - Geokon GeoNet 8900 Series Instruction Manual

6 | NETWORK COMPONENTS | GEOKON

2.4.3 EIGHT-CHANNEL GLAND SEAL (890X-XX-08C-CBL)

FIGURE 6: Eight-Channel Node (890X-XX-08C-CBL)
Note: When inserting stripped conductor wires into the terminal blocks, be sure
to connect them to the VW terminal blocks.
An eight-channel node can be configured as follows:
Model Maximum Number of Gauges
890X‑XX‑08C‑CBL Eight

TABLE 4: Eight-Channel Node Gauge/Load Limits

2.4.4 ADDITIONAL INFORMATION

ADRs are protected from environmental contaminants by a rugged IP66 die cast
aluminum enclosure. An earth ground terminal is provided on the exterior of the
enclosure to protect against lightning and other large, transient voltages.

2.5 TILTMETER NODES

Tiltmeters are designed for permanent long-term monitoring of changes in tilt
of structures such as dams, embankments, foundation walls, retaining walls,
buildings, and the like.
biaxial tiltmeter nodes contain an integrated tiltmeter sensor, and
GEOKON
communicate with the supervisor in the same manner as other nodes.
The two axes of the tiltmeter have a range of ±90°, based on a starting position
of 0°. To achieve the best linearity, mount the tiltmeter so the back of the
enclosure is as close as possible to vertical, and the bottom of the enclosure is
as close as possible to horizontal.
Though designed to send data wirelessly to a mesh supervisor, this model also
features a USB connector for transferring data using a USB cable to a PC
running Agent software, the same as with the single channel nodes.
Maximum Number of Load Cells
One 3‑gauge and one 4‑gauge load cell
Two 3‑gauge or two 4‑gauge load cells
One 6‑gauge load cell
6:
4: