Table 7: Led Indicator Meaning; Table 8: Status Button Functions - Geokon GeoNet 8900 Series Instruction Manual

The table below shows the meaning of the various LED indications.
LEDs Gateway
Green Time set, Loggers present
Green Red Time set, no Loggers present
Red Network time not set

TABLE 7: LED Indicator Meaning

When the Status button is pressed on the gateway, the LEDs briefly display the
network status. If the network is in Deployment mode when the button is
pressed, the Deployment mode timer will reset. If the network is not in
Deployment mode, it will enter Deployment mode on the following radio cycle.
This could take up to six minutes, as changes to the radio settings can only
occur when all the radios in the network are awake. In order to provide timely
feedback to the user, the network parameters are set to a 10-second radio
interval while the gateway is in Deployment mode.
When the Status button is pressed on a logger, the LEDs briefly display the radio
signal status. The logger will indicate the status of the radio signal after each
radio transmission for a period of 10 minutes. If a logger has not yet joined the
network, it will change its radio interval to approximately one second and search
for an available network.
Device Function
Gateway or Logger Reset
Gateway Put the network into Deployment mode/extend Deployment
mode. Display the current status.
Gateway Take a reading and send existing data immediately
Display the current status, then indicate signal strength
Logger
every radio cycle for 10 minutes

TABLE 8: Status Button Functions

MODEL 8900 SERIES GEONET WIRELESS DATA HOSTING SYSTEM | NETWORK INSTALLATION | 23
Loggers
GOOD: Radio signal > 30%
MARGINAL: Radio signal < 30%
BAD: No radio signal
Status Button Action
Press and hold until both LEDs
illuminate (~10 seconds)
Press and release
Press and release
Press and release
7:
8: