Select A Location; Assemble The Mounting Bracket; Install The Mounting Bracket; Secure The Solar Panel To The Mounting Bracket - Geokon GeoNet 8900 Series Instruction Manual

F.1 SELECT A LOCATION
Choose a location for the solar panel that is clear of obstructions and anything
that might cast a shadow on the panel.
F.2 ASSEMBLE THE MOUNTING BRACKET
When assembling the two sections of the mounting bracket, be sure to set the
sections to the desired angle before tightening the nuts. The angle of the
mounting bracket will dictate the angle of the solar panel.
■
Ensure the angle is at least 10 degrees, to aid in water control.
■
In general, choose the best angle for the latitude of your location.
■
Mounting on a horizontal surface will require a reverse configuration of the
two sections compared to mounting vertically. See the figure below.
Horizontal Mounting
FIGURE 45: Mounting Options
F.3 INSTALL THE MOUNTING BRACKET
Mount the bracket on a flat surface (roof, wall, etc.) using locally-supplied bolts
or lag screws. If mounting to a pole, use locally-supplied U-bolts and retaining
clamps.
F.4 SECURE THE SOLAR PANEL TO THE MOUNTING BRACKET
Use the included nuts and screws to secure the solar panel to the mounting
bracket. Use the centrally-located holes provided for this purpose on the back of
the solar panel.
Note: Be sure to mount the solar panel with the cable coming out the bottom of
the panel, as shown below.
FIGURE 46: Centrally-Located Mounting Holes
MODEL 8900 SERIES GEONET WIRELESS DATA HOSTING SYSTEM | SOLAR PANEL KIT | 39
45:
Vertical Mounting
46:
Central Mounting
Holes