Nfc Module Cable - HP EliteBook x360 1040 G7 Maintenance And Service Manual

9. Remove the touchpad from the computer (4).
Reverse this procedure to install the touchpad.

NFC module cable

To remove the NFC module cable, use this procedure and illustration.
NOTE: The NFC module cable is available in the Cable Kit, spare part number M20835-001.
Table 5-9 NFC module cable description and part number
Description
NFC module cable:
NOTE: The NFC module cable spare part kit does not include the NFC module cable cable. The NFC module
cable cable is available in the Cable Kit, spare part number M20835-001.
Before removing the NFC module cable, follow these steps:
1. Prepare the computer for disassembly
2. Remove the bottom cover
3. Remove the battery (see
Remove the NFC module cable:
1. Detach the NFC module cable (1) from the top cover/keyboard. (The NFC module cable cable is attached to
the top cover/keyboard with double-sided adhesive.)
2. Release the ZIF connector (2) to which the NFC module cable cable is connected, and then disconnect the
cable from the system board.
ENWW
(Preparation for disassembly on page
(Bottom cover on page 44).
Battery on page 45).
Spare part number
M16045-001
44).
Component replacement procedures 59