Nfc Module Cable - HP EliteBook x360 1040 G8 Maintenance And Service Manual

9. Remove the touchpad from the computer (4).
Reverse this procedure to install the touchpad.

NFC module cable

To remove the NFC module cable, use this procedure and illustration.
NOTE: The NFC module cable is available in the Cable Kit, spare part number M20835-001.
Before removing the NFC module cable, follow these steps:
1. Prepare the computer for disassembly (see
2. Remove the bottom cover (see
3. Remove the battery (see
Remove the NFC module cable:
1. Disconnect the cable from the ZIF connector on the NFC module (1).
2. Disconnect the cable from the ZIF connector on the system board (2).
50 Chapter 5 Removal and replacement procedures for authorized service provider parts
Preparation for disassembly on page
Bottom cover on page
Battery on page 36).
35).
35).