Table of Contents
Advertisement
(2) Please do not upload new firmware by wireless data transmission because it has missed the reset
signal.
(3) If there's without firmware version number, it means failed upload new firmware. It may cause of
network problem, please re-upgrade firmware until shows the version.
Click "Yes" to install the firmware,
Disconnect the USB cable, click OK and then reconnect USB cable immediately (Pay attention: Turbo
Pix will have failed to connect if there are more than one COM, please remove other equipment if
disconnect).
Red status LED means the Turbo Pix is loading the firmware.
After upgrade firmware 3.1 or after version 3.1,there will be a pop-up warning motors will run at idle speed
after disarmed.
Please click "CONNECT" to connect your Turbo Pix and computer when firmware has installed successful. it
turns to green means connect successful.
6
Radiolink Electronic Ltd
www.radiolink.com
Advertisement
Table of Contents
