Control Panel - Flex ADM 60-T Operating Instructions Manual

FLEX ADM 60–T

Control panel

To activate, touch the marked area
of the touch-sensitive control panel.
15 Measurement button
Briefly pressing the button switches the
laser beam on or actuates the measure-
ment (depending on selected measuring
mode). Holding down the button starts
a continuous measurement
16 Measuring mode button
Switches the measuring modes in succes-
sion: Area measurement
surement , single Pythagorean
Pythgorean linear measurement
17 Min/Max button
Activates the maximum or minimum
measurement.
14
18 Unit of measurement button
19 Plus/Minus button
20 Reference plane button
21 Save button
.
, volume mea-
, double
22 Clear button
.
Switches the units of measurement in suc-
cession: metric (m, mm), Anglo-American
(ft, in).
For adding + or subtracting – measured
values.
Switches the reference planes in succes-
sion: Base of device
front of device , stop pin
To save the current measured value, hold
down the button for 3 seconds. A maximum
of 20 measured values can be saved.
To retrieve the measured values from
the memory, briefly press the button.
The measured value last saved is dis-
played. Press the Plus/Minus button
to retrieve the saved measured values
in succession. Press the Clear button
to delete the value currently displayed.
Deletes the last measured value or swit-
ches on linear measurement (depending
on selected measuring mode).
, ¼" thread ,
.