Integration To Wlan Network - VIPA TP 606C CAN Manual

Chapter 2 Deployment Touch Panel

Integration to WLAN network

Overview
WLAN via
SDIO card
Installation
WLAN via
USB stick
Installation
WLAN integration
2-24
By plugging a WLAN card there is the possibility to integrate your Touch
Panel to a WLAN network. For this driver for the corresponding WLAN
hardware are pre-installed.
Please regard only SDIO WLAN cards are supported which drivers are pre-
installed in the Touch Panel. In the Touch Panel driver exist for the
following SDIO cards:
• Socketcom P300
• Spectec SDW821
• JustMobile Wireless LAN Card.
• PowerON the Touch Panel.
• Plug the SDIO card → the SDIO card is identified and a dialog window,
which shows the available WLAN networks, is opened.
• Continue with "WLAN integration".
Please regard only WLAN-USB sticks are supported with the chip of the
company Funkwerk inside!
• PowerOFF the Touch Panel.
• Plug the WLAN USB stick to the USB-A interface.
• PowerON the Touch Panel → the driver name is requested.
• Enter "prisma02" → now your card is installed and activated.
Note!
To keep the settings also after PowerON, you have to store them to the
registry with START > Programs > KuK Tools > Save Registry.
Directly after installation a dialog window is shown. Here the available
WLAN networks are displayed.
Chose the corresponding network and click to [Connect].
At a safety-relevant network set the network parameters and enter the
network key. If the parameters are correct the connection is established.
HB160E - TP - RE_606-1BC40 - Rev. 08/13
Manual VIPA HMI