Chapter 1 Hardware description
Dimensions
Installation
dimensions
6.5''
606-1BC40
1-10
For the installation of the Touch Panel in control cabinets and desks the
following dimensions are necessary:
Installation cutting (W x H)
Front panel (W x H)
Installation depth
Note!
The degrees of protection are only guaranteed when the following is
observed:
• Material thickness at the mounting cut-out: 2 ... 5mm
• the deviation from the plane for the panel cut-out is ≤0.5mm. This
condition must be fulfilled for the mounted HMI device
• Permissible surface roughness in the area of the seal: ≤120µm (friction
coefficient 120)
installation width
width
HB160E - TP - RE_606-1BC40 - Rev. 08/13
Manual VIPA HMI
installation
depth
200 x 144mm
212 x 156mm
37mm