Commissioning - VIPA TP 606C CAN Manual

Chapter 2 Deployment Touch Panel

Commissioning

VIPA Startup
Manager
Start
Select
Exit
Backup
Restore
2-4
Attention!
• Before commissioning the device must be brought to room temperature.
• At condensation the device must be absolutely dry before connected to
power.
• To avoid overheat during operation the device must not be laid open to
direct sun light.
• After opening the control cabinet or desk, there are parts with possible
dangerous voltage available.
• For all signal connections only screened cables are permitted.
• Signal cables must not be let within the same cable shaft as high
voltage cables.
As soon as the Touch Panel is provided by power supply the Touch Panel
starts with the VIPA Startup Manager:
The VIPA Startup Manager has the following buttons:
A project is started within the VIPA Startup Manager after a configured time
was passed. The project may be started immediately by means of [Start].
Depending on the installed visualization software the project to be started
may either be selected with [Select] or within the editor of the visualization
software. For an automatically start of the project the project may once be
started manually by [Start] if necessary.
The VIPA Startup Manager is closed by [Exit] and it is returned to
®
Windows CE.
With [Backup] the files of the Flashdisk and the Registry settings may be
stored.
The backed up files may be restored by [Restore].
HB160E - TP - RE_606-1BC40 - Rev. 08/13
Manual VIPA HMI