VIPA TP 606C CAN Manual page 17

Manual VIPA HMI
"Host"-USB-A
4
3
2
1
"Slave"-USB-B
2 1
3 4
VIPA USB-B
Programming cable
Power supply
DC 24V
HB160E - TP - RE_606-1BC40 - Rev. 08/13
Using the "Host"-USB-A interface mouse, keyboard, USB stick ore USB
hard discs can be connected.
The pin assignment is as follows:
"Host"-USB-A:
Pin Assignment
1 VCC
2 DM
3 DP
4 GND
For project transfer with Microsoft ActiveSync a programming cable can be
connected using the "Slave"-USB-B interface.
The pin assignment is as follows:
"Slave"-USB-B:
Pin Assignment
1 VCC
2 DM
3 DP
4 GND
The USB-A interface of your PC can be connected to the "Slave"-USB-B
interface of your Touch Panel deploying the USB programming cable.
The USB programming cable is delivered by VIPA with order No.
VIPA 670-0KB10.
The Touch Panel has got an integrated power supply. The power supply
has to be provided with DC 24V (20.4 ... 28.8V). For this you find an
according DC 24V slot at the bottom side.
The power supply is protected against inverse polarity and overcurrent.
Chapter 1 Hardware description
1-9