VIPA TP 606C CAN Manual page 34

Chapter 2 Deployment Touch Panel
Install partnership
via Ethernet
2-14
If your Touch Panel shall be available via Ethernet you have to install a
partnership for USB communication first like shown above. Afterwards you
may configure a partnership for Ethernet communication after the following
approach:
• To enable the Touch Panel to be accessed via Ethernet you have to
activate the option "enable network connection" in ActiveSync via File >
Connection Settings:
• Disconnect the USB cable of the Touch Panel.
• Confirm the message that the device could not be found.
• Start the communication program required for ActiveSync at the Touch
Panel via START > Programs > Communication > Act.Sync Netw and
click on [Connect].
Now you may access the Touch Panel with ActiveSync via Ethernet.
Note!
To keep the settings also after power on, you have to store them to the
registry with START > Programs > KuK Tools > Save.
HB160E - TP - RE_606-1BC40 - Rev. 08/13
Manual VIPA HMI