Installation Of The Brake - Lenze m500-P Series Operating Instructions Manual

8 Maintenance/repair
Installation of a spring−applied brake

Installation of the brake

8.4.2 Installation of the brake
(
Stop!
¯ Check the state of the end shield (15). It must be free from oil and
grease.
15
4
3
Fig. 3 Rotor mounting
3 Rotor
1. Push the rotor (3) onto the hub (4) and check whether it can be moved by hand
(Fig. 3).
(
Stop!
Please note the following for the version "brake with shaft sealing ring in
torque adjustment ring":
2. Lightly lubricate the lip of the shaft seal with grease.
3. When assembling the stator (1), push the shaft sealing ring carefully over the
shaft.
–
The shaft should be located concentrically to the shaft seal.
4. Use the screws (10) to mount the stator (7) completely to the end shield (15)
(Fig. 4).
–
Tighten the screws evenly, tightening torque (¶ 49).
1
10
Fig. 4 Stator mounting
1 Stator
10 Cheese head screw
50
4 Hub
9

15
9 Sleeve bolt
15 End shield
K14.0502/8
15 End shield
KL458−012−a
¬ s
Lrated
Lenze ¯ BA 33.0008 ¯ 5.0