EHEIM incpiria 200 marine Operating Instructions Manual page 15

GB
Remove any foreign matter such as dust, sand, etc. from the underside of the aquarium base
and the top of the furniture.
Place the aquarium on the furniture. Do not place any mats / underlays between the aquarium
and the furniture.
C Installation
The screw connections and standpipes in the base plate of the aquarium have already been
installed in the factory and screwed on safely with the necessary amount of torque.
The installation process that you need to carry out is limited to the following small number of
steps:
C Power cable
Rear view: Pass the power cable for the lighting through the dry, rear supply shaft.
Tip: for easier insertion of the cable through the drilled hole, use a long, blunt item such as a
stick or ruler to help.
C Mounting the inlet
Plan view:
 Outlet hose (already installed)
 Safety outlet hose (already installed)
 Inlet hose
Attach the outlet spout  to the inlet hose .
See Figure C for the positioning of the outlet
C Connecting the filter tank
Place the filter tank on the foam mat and then place it into the piece of furniture
Arrangement of the filter tank:
 Inflow filter chamber with a constant water level of approx. 22cm
(Chamber for later installation of the protein skimmer)
 Filter chamber
 Collection chamber
 Osmosis water storage chamber (only in the "incpiria marine 300/400/500" model)
For the storage of osmosis water as well as connection to an automatic refilling device
C Connecting the hoses
1. Screw the assembled hose connection  with the flat seal inlaid in the union nut
onto the thread of the standpipe channel  from below
Place the end of the hose in the inflow chamber 
2. Screw the assembled hose connection  with the flat seal inlaid in the union nut
onto the thread of the standpipe channel  from below