Storage, Transport And Unpacking - ProMinent Sigma/3 Basic S3Ba Series Operating Instructions Manual

3

Storage, transport and unpacking

Safety notes
Scope of supply
Storage
Ambient conditions
WARNING!
Only return metering pumps for repair in a cleaned state and
with a flushed liquid end - refer to "Decommissioning!
Only return metering pumps with a completed Decontamina‐
tion Declaration form. The Decontamination Declaration con‐
stitutes an integral part of an inspection / repair order. A unit
can only be inspected or repaired when a Declaration of
Decontamination Form is submitted that has been completed
correctly and in full by an authorised and qualified person on
behalf of the pump operator.
You can find the "Decontamination Declaration" form under
www.prominent.com/en/downloads or on the CD.
CAUTION!
Danger of material damage
The device can be damaged by incorrect or improper storage
or transportation!
– The unit should only be stored or transported in a well
packaged state - preferably in its original packaging.
– Only transport the unit when the red gear bleeding plug
is pushed in.
– The packaged unit should also only be stored or trans‐
ported in accordance with the stipulated storage condi‐
tions.
– The packaged unit should be protected from moisture
and the ingress of chemicals.
Compare the delivery note with the scope of supply:
Personnel:
n
1. Plug the caps on the valves.
2. Check if the red gear bleeding plug is pushed in.
3. Preferably place the pump standing vertically on a pallet and secure
against falling over.
4. Cover the pump with a tarpaulin cover - allowing rear ventilation.
Store the pump in a dry, closed shop under the following ambient condi‐
tions.
- refer to "Technical Data" chapter.
Storage, transport and unpacking
Technical personnel
11