Dake 150H Instructional Manual page 8

• This machine is intended to be operated by one person. This person should be
conscious of the press ram movement not only for themselves but also for persons in the
immediate area of the machine.
• Tag out procedures must be followed by authorized employees as per OSHA.
• Hydraulic – Relieve all hydraulic pressure before servicing the press. Turn the red
release handle to relieve the pressure.
• Spring Pressure – Clamp ring on bottom of piston must be in place before removing
cylinder.
• Hoist and table channel – always place table pins under the table channels then install
the remaining pins. Always release pressure on the cable before using press.
Label Placement View
Label Part No. 300168
907005
Label Part No.
84487
Label Part No.
607
7
Dake Corporation
724 Robbins Road
Grand Haven, MI 49417
www.dakecorp.com
Label Part No. Label Part No.
84399
Label Part No.
634
6767
REV112019